- DRAW COMMANDS
Limit
As a first step for drawing area setup need to set limits on screen
for that Limit command is used
¡The limits
command allows to change the upper and lower limits of the drawing area. The
lower limit is normally kept at 0, 0 and the value of the upper right corner
depends upon the size of the figure to be drawn. The default size is 12x9
units. The size of the upper right corner should be slightly more than the size
of the figure to be drawn
¡Command: LIMITS
¡Reset Model space limits:
¡Specify lower left corner or [ON/OFF] <0.000; 0.000>: 0, 0 (Enter)
¡Specify upper right corner <12.000, 9.000>: 297, 210 (Enter)
For more detail related to draw command you may concern a video given below that will help you to learn about draw commands
¡Command: LIMITS
¡Reset Model space limits:
¡Specify lower left corner or [ON/OFF] <0.000; 0.000>: 0, 0 (Enter)
¡Specify upper right corner <12.000, 9.000>: 297, 210 (Enter)
For more detail related to draw command you may concern a video given below that will help you to learn about draw commands
May 14, 2020
Tags :
Practical
Subscribe by Email
Follow Updates Articles from This Blog via Email
No Comments